ZyXEL Communications P-660H-T Series - Manual (Page 81)

P-660H/HW-T Series User’ Guide
Chapter 5 Wireless LAN 80
5.7.1 No Access Allowed or Authentication
Select No Access Allowed or No Authentication Required in the Wireless Port
Control field.
Figure 25 Wireless LAN: 802.1x/WPA: No Access Allowed
Figure 26 Wireless LAN: 802.1x/WPA: No Authentication
The following table describes the label in these screens.
5.7.2 Authentication Required: 802.1x
You need the following for IEEE 802.1x authentication.
Table 15 Wireless LAN: 802.1x/WPA: No Access/Authentication
LABEL DESCRIPTION
Wireless Port
Control
To control wireless station access to the wired network, select a control method from
the drop-down list box. Choose from No Access Allowed, No Authentication
Required and Authentication Required.
No Access Allowed blocks all wireless stations access to the wired network.
No Authentication Required allows all wireless stations access to the wired network
without entering usernames and passwords. This is the default setting.
Authentication Required means that all wireless stations have to enter usernames
and passwords before access to the wired network is allowed.
Select Authentication Required to configure Key Management Protocol and other
related fields.
Back Click Back to go to the main wireless LAN setup screen.
Apply Click Apply to save your changes back to the Prestige.
Cancel Click Cancel to begin configuring this screen afresh.