Zebra Technologies Zebra P120i - Manual (Page 51)

P120i Printer Setup
Loading Cards
980504-001 Rev. A P120i Card Printer User Guide 41
Loading Cards
To help you load, print, and collect cards, the P120i has the following items:
Card Feeder
The card feeder is used for loading cards, it can hold up to 100 cards of 30 mils thickness. The
card feeder is located under the card feeder cover
of the P120i printer.
Load cards into card feeder as follows:
1. Open card feeder cover.
2. Slide card guide all the way to the right until it locks in place with an audible click.
3. Remove cellophane wrapper from card stack.
Caution • DO NOT bend cards or touch print surfaces as this can reduce print
quality.
Note • The surface of the cards must remain clean and dust free. Always store cards in an
enclosed container. Ideally, use cards as soon as possible. If cards stick together, carefully
fan or shuffle them.
Note • For Cards with magnetic stripe refer to Appendix A for loading instructions.
Note • Static charges and edge burrs from the card die-cutting process can render individual
cards stuck together with significant adhesion force. These cards must be physically
separated from each other before inserting into the feeder; if not separated, feeding or
printing problems may occur.
CARD
GUIDE
CARD FEEDER