Zebra Technologies XiIII Series - Manual (Page 90)

82 Zebra XiIII-Series User’s Guide
CANCEL Key Self Test
This self test prints a listing of the
configuration parameters currently
stored in the printer’s memory. See
Figure 33 (depending on the options
ordered, your label may look different).
1. Turn the printer off.
2. Press and hold the CANCEL key
while turning on the power.
The configuration may be changed
either temporarily (for specific label
formats or ribbon and label stock) or
permanently (by saving the new
parameters in memory). Saving new
parameters occurs whenever a
calibration procedure is performed.
Refer to page 15 for further information
about the configuration procedure.
Additional Power-Up Self Tests are also
performed during the POST for this test.
Figure 33