Zebra Technologies XiIII Series - Manual (Page 40)

32 Zebra XiIII-Series User’s Guide
&XWWHU 0RGH
NOTE: Cutter option required.
Refer to Figure 19.
1. Open the printhead.
2. Slide the media guide and media supply guide as far from the printer
frame as possible. Flip down the media supply guide.
3. Load media as shown.
4. Flip up the media supply guide. Slide in the media guide and media
supply guide so they just touch, but don’t restrict, the edge of the roll.
5. Close the printhead.
6. The printer automatically feeds out and cuts one label when the printer
is turned on.
Figure 19