Zebra Technologies XiIII Series - Manual (Page 101)

Zebra XiIII-Series User’s Guide 93
®®l›c‹à
3ULQWHU ,QWHUIDFH 7HFKQLFDO ,QIRUPDWLRQ
565656 6HULDO 'DWD 3RUW
The connections for these standard interfaces are made through the
DB-25S connector on the rear panel. For all RS-232 input and output
signals, the printer follows both the Electronics Industries Association’s
(EIA) RS-232 specifications and the Consultative Committee for
International Telegraph and Telephone (CCITT) V.24 standard signal level
specifications.
The following table shows the pin configuration and function of the rear
panel serial data connector on the printer.
Pin No. Description
1 FG (frame ground) for cable shield
2 TXD (RS-232 transmit data) output from printer
3 RXD (RS-232 receive data) input to printer
4 RTS (RS-232 request to send) output from printer
6 DSR (data set ready) input to printer
7 SG (signal ground) for RS-232
9 +5 VDC source output (1 Amp maximum)
11 SGR (signal ground reference) for RS-422/RS-485
13 Data input B(-); RS-422/RS-485
14 Data output B(-); RS-422/RS-485
16 Data input A(+); RS-422/RS-485
19 Data output A(+); RS-422/RS-485
20 DTR (RS-232 data terminal ready) output from printer
NOTE: Pins 5, 8, 10, 12, 15, 17-18, 21-25 are unused and unterminated.