Zebra Technologies XiIII Series - Manual (Page 35)

Zebra XiIII-Series User’s Guide 27
5ROO 0HGLD /RDGLQJ
NOTE: A calibration must be performed when media and ribbon (if used)
are first installed in the printer, or when a different type of media
or ribbon is being used.
7HDU2II 0RGH
Refer to Figure 16.
1. Open the printhead.
2. Slide the media guide and media supply guide as far from the printer
frame as possible. Flip down the media supply guide.
3. Load media as shown.
4. Flip up the media supply guide. Slide in the media guide and media
supply guide so they just touch, but don’t restrict, the edge of the roll.
5. Close the printhead.
Figure 16