Zebra Technologies XiIII Series - Manual (Page 81)

Zebra XiIII-Series User’s Guide 73
$GMXVWPHQWV
7RJJOH 3RVLWLRQLQJ
Both toggles should be positioned so that they provide even pressure on
the media. The toggles are positioned by sliding them to the desired
location. On media too narrow to accommodate both toggles, position one
toggle over the center of the media and decrease the pressure on the
unused toggle. If you are using a 90 or 96XiIII printer, position the single
toggle over the center of the media.
NOTE: Make sure that the toggle pressure is even across the width of the
media. Otherwise, the media and/or ribbon may “drift.”
Figure 32