Xerox 83xx - Manual (Page 34)

3-20
3.3.2.3 Adjusting the roll units
Procedure
Step 1 :
Use the correct amount of spacers (2) to cover the space between the drawn lines (1).
No Description
1 Drawn lines
2 Spacer
Step 2 :
Determine the deviation of the roll unit using the image and table below.
Adjusting the FRONT Units
IF line 2 lays… THEN…
BEFORE line 1 Remove spacers on the left front unit or add spacers on the right front unit.
BEHIND line 1 Add spacers on the left front unit or remove spacers on the right front unit.
Adjusting the REAR Units
IF line 2 lays… THEN…
BEFORE line 1 Add spacers on the left rear unit or remove spacers on the right rear unit.
BEHIND line 1 Remove spacers on the left rear unit or add spacers on the right rear unit.