Xerox 83xx - Manual (Page 23)

3-9
3.2.5 Connecting the cables.
Caution
• Use a power cable that is suitable to the local power specifications when connecting the UW/W 100 to
the power grid.
• If the kit is separately ordered from a printer as an optional item, then a power cable is included in the
UW/W 100 kit
• If the UW/W 100 kit has been delivered with a new printer as a standard in the box item, then the
power cable is located in the printer’s packaging box, not in UW/W 100 packaging box.
Step 1 : Connect the power cable to the power supply connector.
Step 2 : Check if the all cables of the UW/W are connected to the correct connector (1 to 6). See image
below for the location of the connectors.
Nr Description
1 Power supply connector
2 Front motorized unit connector
3 Rear motorized unit connector
4 Foot switch connector
5 Not used
6 Operation panel connector
Notes
With a small intervention it is possible to reverse your winding direction.
Mount the Motor twist cable between the control box and the front motorized unit cable.
Notes
Check if the cable to the operation panel is connected properly on both sides.