Xerox 83xx - Manual (Page 29)

3-15
Step 3 : Use the 2 screws (1) in the tension bar bracket to adjust the tension system. Referencing the
figures below Line 1 is drawn in Position 1 and Line 2 in drawn in Position 2.
Tool : Hexagon wrench 3 mm
REAR REAR
1 = Adjustment screws
IF Line 2 lays… THEN turn the adjustment screws as follows :
BEFORE line 1 (Case A on image above)
BEHIND line 1 (Case B on image above)
Caution
•
Make sure to turn both adjustment screws an equal amount of turns.
Step 4 :
Check the calibration again and repeat the adjustment until the lines overlap each other.