I/o card installation procedure – Yamaha 1009MWTO-F0 User Manual
Page 21
Set
up
I/O Card Installation
DME64N/DME24N Owner’s Manual
21
I/O Card Installation Procedure
1.
Make sure that the DME64N/24N power is OFF.
If the power is on, turn it off.
2.
Loosen the two card slot screws and remove the slot cover, as shown in the diagram.
3.
Slide the I/O card into the slots in the guide rails, as shown in the diagram, and push the
card into the slot.
Be sure to push the card all the way back into the slot so that the card contacts make proper contact with
the slot connector.
4.
Secure the card with the attached screws.
Be sure to tighten the screws securely. If the screws are left loose proper contact may be lost and
malfunction of damage may result.
NOTE
The slot cover and screws will need to be re-attached if the I/O card is later removed from the slot, so keep
them in a safe place.
Guide Rail
CAUTION
- DIO8 (9 pages)
- RM800 (163 pages)
- EMX88s (34 pages)
- EMX212S (36 pages)
- MOTIF XF 1.1 (4 pages)
- GA24/12 (26 pages)
- DM 2000 (410 pages)
- M7CL-48 (312 pages)
- WD83390 (388 pages)
- MOTIF XF (11 pages)
- WC42260 (403 pages)
- EN55103-1 (4 pages)
- 01V96 VCM (1 page)
- QY 300 (13 pages)
- PM5D-RHPM5D (367 pages)
- MC3210M (58 pages)
- SP2000 (2 pages)
- MB02R96 (2 pages)
- MC2403 (61 pages)
- MG166C-USB (37 pages)
- MC803 (61 pages)
- MG102Cc (21 pages)
- DIGITAL MIXING STUDIO 01X (156 pages)
- LS9 (2 pages)
- LS9 (290 pages)
- DSP5D (409 pages)
- WA66540 (28 pages)
- EMX66M (30 pages)
- AX44 (51 pages)
- MX200-24 (57 pages)
- RM602 (44 pages)
- MX200-12 (57 pages)
- MBM7CL (2 pages)
- AX16-AT (65 pages)
- MB1000 (2 pages)
- MT44D (43 pages)
- DSP1D-EX (8 pages)
- MX200-16 (57 pages)
- EMC5014C 14-Channel 1000W Powered Mixer (37 pages)
- WK83840 (80 pages)
- MC1602 (48 pages)
- MM1242 (50 pages)
- IM8-32 (33 pages)
- DIGITAL SOUND PROJECTOR HTY-750 (98 pages)