The controls and connectors, Front panel, Usb] connector – Yamaha 1009MWTO-F0 User Manual

Page 14: Ext. clock] indicator, Network] indicator, Dme64n dme24n

The Contr

ols and Connect

or
s

Front Panel

DME64N/DME24N Owner’s Manual

Front Panel

[USB] Connector

A computer can be connected here when it is necessary
to program or control the device. When a USB
connection is to be used, the USB-MIDI driver must be
installed on the computer. Refer to the DME Designer
Installation Guide for installation instructions.

[EXT. CLOCK] Indicator

When a clock signal from an external device is selected,
the indicator will light green. If the clock signal is not
appropriate the indicator will flash red. The indicator will
go out when the internal word clock is selected.

[96kHz] [88.2kHz] [48kHz] [44.1kHz]
Indicator

Normally, the indicator corresponding to the current
word clock frequency will light green. If a problem with
the master clock is detected all of these indicators will
flash red. 2 seconds after a problem is detected with an
external master clock the internal clock will temporarily
be selected. When this happens the indicator
corresponding to the frequency of the internal clock will
light green, and all other indicators will continue to flash
red.

[NETWORK] Indicator

Lights while data communication is occurring via the
[USB], [NETWORK], or [CASCADE] connector. Received
data causes the indicator to light in green, while
transmitted data causes the indicator to light in orange.
If a problem occurs the indicator will light in red.

The Controls and Connectors

HOME

UTILITY

SCENE

LEVEL

MUTE

ENTER

CANCEL