Yamaha DVX-S200 - Manual (Page 82)

Types of Input Signals
78
Switching Input Modes
TV
CH
CINEMA
CH
POWER POWER
AUDIO
/DTS SELECT
NIGHT SW
TV CH
TV INPUT
SLEEP
PRESET PRESET
A B C D E
CENTER SURR
SHIFT
STEREO MATRIX 6.1
A-B REPEAT
ANGLE SUBTITLE
DVR-S200 WB56620
ON SCREEN MENU
TEST
RETURN STATUS
TV VOL VOLUME
MUTE
AMP
DVD/CD VCR VIDEO 1
VIDEO 2 TUNER MD/CD-R
MOVIE MUSIC SPORTS GAME
SET MENU
ENTER
• It is possible to switch Input mode even if you press INPUT on CinemaStation for more than one second.
• When Input mode is set to AUTO and a Dolby Digital or DTS signal is input, the most suitable decoder is automatically
selected.
• The following happens when set to Input mode and DTS is played:
— CinemaStation detects the DTS signal and automatically switch to DTS mode (t indicator lights up). Once DTS audio
finishes playback, the t indicator may blink, and while it blinks only DTS audio can be played back. Immediately after
DTS audio finishes playback, if you want to play normal PCM audio, reset the Input mode to AUTO.
— If the DTS signal is interrupted when you perform Search or Skip, the t indicator may blink. If this condition continues
for over 30 seconds, the Input mode automatically changes from DTS to normal digital (PCM) and the t goes out.
• Using “* Input Mode” in the SET MENU you can set whether to use the Input mode specified previously when CinemaStation
was turned on or return to AUTO.
• It is not possible to select ANLG with the DVD/CD Input Selection button.
• You cannot switch input modes when the input jack you select with the Input Selection button can only accept an analog input
signal.
• To play back DTS, set the Input mode to AUTO or DTS. Do not set it to ANLG. If you do, audio may not output or you may
hear noise.
You can playback most sources without a problem with
the AUTO setting (factory default setting). Then depending
on your needs, you can select the priority level for digital
and analog input signals, and specify formats such as
DTS.
Press the Input Selection button for current input
source until the desired input mode appears in the
CinemaStation Display.
AUTO: Input signal can be selected in the order below.
1) Digital signal
2) Analog signal
DTS: Only DTS can be played.
ANLG: Only analog signal can be played.
Learning about input modes, jacks and Input Selection
buttons
CinemaStation can receive signals from the VIDEO 1 (analog),
VIDEO 2 (analog), VCR (analog), MD/CD-R (analog), and
OPTICAL (digital) jacks of connected equipment. You can
assign a VIDEO 1, VIDEO 2, VCR or MD/CD-R input name to
the OPTICAL IN jack. This will allow you to use the VIDEO 1,
VIDEO 2, VCR or MD/CD-R button to input a device
connected to the OPTICAL IN jack (MD/CD-R is assigned in
the default setting.) Normally, an analog signal is input to the
VIDEO 1, VIDEO 2, VCR or MD/CD-R IN jack, and a digital
signal is input to the OPTICAL IN jack. However, by setting
the input mode to AUTO the input will be automatically
detected and you can then playback audio from the device you
want by simply pressing an Input Selection button.
Advice
Notes
Input
Selection
buttons
Notes
• U.K. and Europe models only have VIDEO instead of VIDEO 1 and
VIDEO 2.
• VIDEO is used as VIDEO 1 in above models.
014DVX-S200-en 04.3.1, 11:20 AM 78