beautypg.com

Installation – Zanussi ZM266STG User Manual

Page 53

background image

51

INSTALLATION

The electrical outlet should be readily accessible so that

the unit can be unplugged easily in an emergency.

The socket should not be positioned behind the cupboard.
• The best position is above the cupboard, see (A).

When not connecting the power supply cord to position (A) it should
be removed from the support clip (see diagram, item 14, on page 5)
and routed under the oven.

• Connect the appliance to a single phase 230-240V/50Hz alternating

current via a correctly installed earth socket.
The socket must be fused with a ≥16A fuse.

If the appliance is to be operated in a non-European

country, the supply voltage, current type and frequency of the appliance indicated on
the rating plate must correspond with the specification of your power supply. The
rating plate can be found on the inside face of the control panel.

The power supply cord may only be replaced by an electrician.
• Before installing, tie a piece of string to the power supply cord to facilitate connection to point (A) when

the appliance is being installed.

• When inserting the appliance into the high-sided cupboard, DO NOT crush the power supply cord.

CONNECTING THE APPLIANCE TO THE POWER SUPPLY

(A)

ELECTRICAL CONNECTIONS

• If the plug that is fitted to your appliance is not

suitable for your socket outlet, it must be cut off
and the appropriate plug fitted.

• Remove the fuse from the cut off plug. The cut off

plug should then be disposed of to prevent the
hazard of shocks in case it should be plugged
into a 13 Amp socket in another part of your
home.

IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:

GREEN AND YELLOW

EARTH

BLUE

NEUTRAL

BROWN

LIVE

If you fit your own plug, the colours of the wires in
the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:

• Connect the green and yellow (earth) wire to the

terminal in the plug which is marked with the
letter ”E” or the earth symbol ( ) or coloured
green and yellow.

• Connect the blue (neutral) wire to the terminal in

the plug which is marked with the letter ”N” or
coloured black.

• Connect the brown (live) wire to the terminal in

the plug which is marked with the letter ”L” or
coloured red.

WARNING:
THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability
should this safety measure not be
observed.

13 AMP

GREEN & YELLOW

13 AMP FUSE

BROWN

CORD CLAMP

BLUE

1. ZD-72D English UK 01/06/2004 09:32 Page 51