Xerox CUSTOMER TIPS 7425/7428/7435 - Manual (Page 6)

Feature Implementation Values
Punch @PJL SET PUNCH =
value1
@PJL SET JOBATTR =
”@PNHN = value2” Where value1 is one of the following:
TOP
RIGHT
LEFT
BOTTOM
NONE
Where value2 is one of the following:
TWO: 2 holes
THREE: 3 holes
FOUR: 4 holes
Folding @PJL SET JOBATTR =
"@FOLD = value1" Where value1 is one of the following:
BIFOLDINSIDE
：Bi-Folding(single page)
BIFOLDMULTIOUTSIDE
：Bi-Folding(multi
page)
The "Collated" feature needs to be enabled for
the booklet functions to work.
Booklet @PJL SET JOBATTR =
“@BKLT = value1”
@PJL SET JOBATTR =
“@BKSG = value2”
@PJL SET JOBATTR =
“@BKDN = int1”
@PJL SET JOBATTR =
“@BKDN = int2”
Where value1 is one of the following:
NONEDIVIDE: Compile a booklet as long
as the number of sheet does not exceed the
limit
AUTODIVIDE: Divide sheets into sets
automatically in case of exceeding the limit
number of sheets.
MANUALDIVIDE : Divide sheets based on
the specified limit manually
OFF : Do not compile a booklet
Where value2 is one of the following:
RIGHT = Right to left page order binding
LEFT = Left to right page order binding
Where int1 is:
1-9999 = Booklet dividing number for each
set
Where int2 is:
1 - 9999 = Booklet total pages of document
Collation @PJL SET QTY = int Where int is:
1 - 999
Resolution @PJL SET RESOLUTION =
value Where value is one of the following:
600
1200
Bits Per Pixel @PJL SET BITSPERPIXEL
= value Where value is one of the following:
1: 1 bit per pixel (per plane)
Quantity @PJL SET COPIES = int Where int is:
1-999
(This parameter used for uncollated mode.)
dc09cc0453
Customer Support
Page 6