Yamaha 01X - Manual (Page 24)

24
Setting Up
01X Owner’s Manual
Before Using
Basics Section
Appendix
Getting Started
Reference
Setting Up
Make sure that the 01X’s [STANDBY/ON] switch is set to
the STANDBY (off) position.
q Connect one end of the AC cable to the PA-300.
w Connect the PA-300’s DC plug to the 01X’s DC IN ter-
minal on the rear panel.
e Connect the other end (normal AC plug) to the nearest
electrical outlet.
• When unplugging the AC Adaptor, disconnect it in reverse order from
that above.
• Do not attempt to use an AC adaptor other than the Yamaha PA-
300 or an equivalent recommended by Yamaha. The use of an
incompatible adaptor may cause irreparable damage to the 01X,
and may even pose a serious shock hazard! ALWAYS UNPLUG
THE AC ADAPTOR FROM THE AC POWER OUTLET WHEN THE
01X IS NOT IN USE.
• Even when the switch is in the “STANDBY” position, electricity
is still flowing to the instrument at a minimum level. When not
using the 01X for an extended period of time, be sure to unplug
the AC power adaptor from the wall AC outlet.
Once you’ve made all the necessary connections (page 23)
between your 01X and any other devices, make sure that
all volume settings are turned down all the way to zero,
then turn on the every device in your setup in the order of
MIDI masters (senders), MIDI slaves (receivers), then
audio equipment (mixers, amplifiers, speakers, etc.). This
ensures smooth signal flow from the first device to the last
(first MIDI, then audio).
• Before beginning installation of mLAN Driver for Windows, switch off
the power to the 01X (see the separate Installation Guide).
• When powering down the setup, first turn down the volume for each
audio device, then switch off each device in the reverse order (audio
devices first, then MIDI).
• Be sure to restart your DAW after restarting the 01X (turning the
power off and on again) or switching the DAW in the Remote Select
menu (page 87). (This applies when using SQ01, Cubase/Nuendo or
Digital Performer.)
• Before you switch your 01X on or off, turn down the volume of
any connected audio equipment.
• Noise may be generated during the following operations. Before
performing these operations, lower the output level of each
device.
• Turning the power to the computer and mLAN devices on or
off
• Connecting or disconnecting an IEEE1394 (mLAN) cable
• Starting or quitting the OS
q Press the [STANDBY/ON] switch.
A splash screen is displayed. The Inter-
nal mode (Home) screen appears next.
w Raise the sound system volume to a rea-
sonable level.
e Turn the 01X’s MONITOR/PHONES
knob clockwise to set an appropriate vol-
ume level.
Power Supply
Power-on Procedure
Rear Panel
PA-300 w DC IN
q
AC cable
To electrical
outlet
e
Turning on the 01X
POWER
ON!!