Yamaha pmn - Manual (Page 85)

E-
79
AD
V
ANCED
OPERA
TION
English
REMOTE CONTROL FEATURES
Learning commands
You can program the remote control commands by transmitting IR
signals from your existing remote controls to the remote control’s
learning eye. To do this, place the remote control and the
component’s remote control on a flat surface, 10 to 20 cm (4 to 8
inches) apart.
The following buttons can be programmed:
• Control panel buttons.
• Device actions.
• Direct-access buttons and left/right buttons.
You cannot program Home menu buttons directly. You must
program components via the Device menu.
The remote control also offers empty control panel buttons that you
can program and label as existing buttons. They are visible only in
the Learn and Label mode and appear with or without labels
(intended for a specific function). You will also see previously
deleted buttons: you can restore them by reprogramming them or
you can reuse them for other commands.
■ Learning control panel buttons
1 1 Navigate to the control panel buttons you want to program.
2 2 Switch to the Learn mode via at the bottom of the touch screen.
Additional empty buttons appear: they can be programmed and labeled as existing buttons.
3 3 Point the component’s original remote control at the remote control’s learning eye.
4 4 Tap the control panel button you want to program.
The button starts flashing.
5 5 Press and hold the corresponding button on your component’s original remote control.
If the remote control has learned the command successfully, “OK” flashes on the upper center of the touch screen. You can release the
button you’re holding.
If the remote control has not learned the command successfully, you will hear a short buzz and “FAIL” will appear on the remote control
icon.
6 6 Program all other buttons you want and relabel them if necessary.
7 7 Return to the Use mode via .
10 to 20cm
(4 to 8 inches)