6ch input – Yamaha pmn User Manual
Page 50
E-
44
To select a source connected to the 6CH INPUT jacks,
Tap
on the INPUT control panel.
“6CH INPUT” appears on the front panel display.
Cautions
• If “6CH INPUT” is shown on the front panel display, no other
source can be played. To select another input source with
INPUT SELECTOR (or one of the input selector buttons on
the INPUT control panel), press 6CH INPUT (or tap
on
the INPUT control panel) to turn off “6CH INPUT” from the
front panel display.
• The input source name corresponds to the jack name to which
the input component is connected. If the component is not
connected to its corresponding jack, input source name and
the playback component do not match. (For example, if a CD
player is connected to the MD input jack and MD is selected
as an input source, the playback sound will be output from the
CD player.) In this case, the input source name can be
changed with “7 INPUT RENAME” on the SET MENU.
4
4
Start playback or select a broadcast station on the
source component.
Refer to the operation instructions for the component.
6CH
INPUT
5
5
Adjust the volume to the desired output level.
If desired, use BASS, TREBLE, BASS EXTENSION and
BALANCE. These controls are only effective for sound from
the main speakers.
Cautions
• If the component connected to the VCR 1 OUT, VCR 2
OUT, VCR 3/DVR OUT, CD-R OUT and MD/TAPE OUT
jacks is turned off, the reproduced sound may be distorted or
the volume may be lowered for the characteristics of A/V
component. In this case, turn on the component.
• While PROCESSOR DIRECT is tuned on, tone controls
(BASS and TREBLE) or/and BASS EXTENSION cannot
be activated.
6
6
Select a DSP program if desired.
on the RECEIVER control panel to open the DSP
control panel. Then tap one of the DSP program buttons.
See pages __ to __ for details about the DSP program.
VOLUME
VOL
VOL
BASS
BASS
EXTENSION
TREBLE
L
R
BALANCE
PROGRAM
BASIC PLAYBACK
6CH INPUT