beautypg.com

Install rails, Slide removal, Install the slides in the cabinet frame – Z Microsystems 15 User Manual

Page 7

background image

Doc# 27-0002UM Issued 7/99 Rev. 1.2

SLIDE REMOVAL

With the Console sitting

on a workbench with the

front facing towards

you, press down to

release the Z-Locks on

each side of the front of

the Console to slide the

side rails back.

The slide rail will reach

a stop about half way

back.
This is a safety stop to

prevent the Console

sliding out too far while

mounted to the rack.
Simultaneously press in

the safety catches on

each slide rail and slide

the side rails all the way

off the back of the

Console.

The slides should now

be separated from the

Console.
Each slide unit includes

the slide rail, with the

front Z-lock mount and

the rear mount.

On the front of the

cabinet frame, use three

Phillips screws on each

side to secure the right

and left Z-Lock mounts.
DO NOT tighten these

screws to allow for

adjustment of the

Console within the

cabinet frame.

On the rear of the

cabinet frame, use the

two Phillips screws to

loosely secure the right

and left rear slide mount

to the cabinet frame.
DO NOT tighten these

screws fully at this time.

On the slide rails, using

a slot screwdriver,

loosen off the screw.

Repeat on each side.

INSTALL THE SLIDES IN THE CABINET FRAME

7

Install Rails