Z Microsystems 15 - Manual (Page 15)

Doc# 27-0002UM Issued 7/99 Rev. 1.2
NOTE: After making changes in
the Setup, the computer
must be Rebooted to
insure proper changes to
the CONFIG.SYS and
AUTOEXEC.BAT files.
NOTE: Before proceeding with
the next section, it is very
important that The Setup
Diskette for Windows 95
or Windows 98 has been
run.
Locate the operating system installed
on the computer in the Table below
and follow the appropriate instruc-
tions. You may choose to run Auto
Setup for each operating system that
is used. This means that if sometimes
the monitor is used while running any
version of Windows and sometimes it
is also used within DOS (not a DOS
window), you must run Auto Setup for
both Windows and DOS. You may run
versions of Auto Setup in any order.
NOTE: If your computer does
not run with the Setup
Diskette shipped with the
monitor, refer to Manual
Setup.
NOTE: The Auto Setup process
only applies to the
current screen mode.
When a new mode is
selected, repeat this
section to reset the
monitor.
AUTO SETUP
Before beginning Auto Setup for the
computer:
• Make a backup copy of the Setup
Diskettes supplied with the monitor.
• Make sure the computer’s video
mode is set in the range of the
supported screen resolution shown
in the table in the Reference section.
Perform Auto Setup for each screen
mode used.
15
Configure Monitor