Z Microsystems 15 - Manual (Page 10)

Doc# 27-0002UM Issued 7/99 Rev. 1.2
Loosen the screws on
each of the front Z-Lock
mounts.
FINAL ADJUSTMENTS OF THE COMMAND CONSOLE
Slide the Console
partially out.
Use a flathead screw
driver to slightly move
the Z-Locks out away
from the Console.
Tighten all the screws on
the front Z-Lock mounts.
Slide the Console in and
out to see if it moves
smoothly.
Go back to the rear of
the rack and fully
tighten the side rail
screws.
Note: A wrench may be
necessary to hold the
nut on the other side.
Install Console
10