Yamaha X-V2600 - Manual (Page 96)

92
SYSTEM OPTIONS
Presence (Presence speakers)
Choices: Yes, None
• Select “Yes” if you have presence speakers.
• Select “None” if you do not have presence speakers.
This unit directs all presence channel signals to the
front left and right speakers.
When Zone2 Amplifier is set to “Internal” (see page 96),
Presence is automatically set to “None”.
Bass Out (Bass out)
LFE signals carry low-frequency effects when this unit
decodes Dolby Digital or DTS signals. These
low-frequency signals can be directed to both front left
and right speakers, and to the subwoofer (which can be
used for both stereo reproduction and sound field
programs).
Choices: Both, SWFR, Front
THX recommendation: SWFR
• Select “Both” to direct LFE signals to the subwoofer.
Front L/R low-frequency signals are directed to both
the subwoofer and front channels, and all other
low-frequency signals are directed in accordance with
other speaker settings.
• Select “SWFR” if you connected a subwoofer. The unit
directs all LFE and low-frequency signals in
accordance with other speaker settings.
• Select “Front” if you have not connected a subwoofer.
The unit directs all low-frequency and LFE signals to
the front speakers (even if you have previously set
Front to Small in Speaker Set).
Bass Cross Over (Bass cross over)
Use this feature to select a cross-over (cut-off) frequency
for all low-frequency signals. All frequencies below the
selected frequency are sent to the subwoofer.
Choices: 40Hz, 60Hz, 80Hz (THX), 90Hz, 100Hz,
110Hz, 120Hz, 160Hz, 200Hz
THX recommendation: 80Hz (THX)
SWFR Phase (Subwoofer Phase)
If bass sounds are lacking or unclear, use this feature to
adjust the frequency phase characteristics of your
subwoofer.
Choices: Normal, Reverse
• Select “Normal” not to reverse the phase for your
subwoofer(s).
• Select “Reverse” to reverse the phase for your
subwoofer(s).
■ Speaker Distance (Speaker distance)
Use this feature to manually input the distance of each
speaker and adjust the delay applied to the respective
channel. Ideally, each speaker should be the same distance
from the main listening position. However, this is not
possible in most home situations. Thus, a certain amount
of delay must be applied to the sound from each speaker
so that all sound will arrive at the listening position at the
same time.
Manual Setup > Basic > Speaker Distance >
Note
Notes
Yes
None
Surround Back
Presence
Bass Out
Bass Cross Over
Surround
Both
SWFR
Front
Surround Back
Presence
Bass Out
Bass Cross Over
SWFR Phase
60Hz
40Hz
80Hz (THX)
90Hz
100Hz
Presence
Bass Out
Bass Cross Over
SWFR Phase
Normal
Reverse
Bass Out
Bass Cross Over
SWFR Phase
Speaker Distance
Speaker Level
Test Tone
Speaker Set
Front L
Front R
Subwoofer
Unit
Center THX Set