Yamaha X-V2600 - Manual (Page 39)

35
AUTO SETUP
PREP
ARA
TION
9
Press n to select Start and then press
ENTER.
Loud test tones are output from each speaker and
“Measuring” appears during the AUTO SETUP
procedure.
y
• To stop the AUTO SETUP procedure, press one of the
cursor buttons ( k / n / l / h) or ENTER. In the pause
mode, press k to retry the procedure,
l
to cancel AUTO
SETUP.
• If an error message appears during testing, refer to
TROUBLESHOOTING on page 126, and after carrying
out the remedy, retry the AUTO SETUP procedure.
You can confirm the results of each analysis.
If you set Setup Type to “Auto”
The results are displayed after all items have been
analyzed.
• Press n and select Setup to set the measured values.
• Press k and select Retry to retry the AUTO SETUP
procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see
TROUBLESHOOTING on page 126.
• Press l and select Exit to exit from the AUTO SETUP
procedure. If you select Exit, “Don’t Setup?” appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
If you set Setup Type to “Step”
The results are displayed individually after each analysis.
• Press n and select Next to start measurement of the next
menu item.
• Press k and select Retry to retry the AUTO SETUP
procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see
TROUBLESHOOTING on page 126.
• Press l and select Exit to exit from the AUTO SETUP
procedure. If you select Exit, “Don’t Setup?” appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
Press ENTER Start
Setup Type
Setup Menu
Confirming the results
Measurement Over
Successfully
Start
Setup Type
Setup Menu Retry
Setup
Exit Detail
Equalizing
Size
Distance
Level
Result
Retry
Next
Exit Detail