Yamaha X-V2600 - Manual (Page 94)

90
SYSTEM OPTIONS
Use this menu to set up basic system parameters.
1
Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
2
Press k / n on the remote control to select
Manual Setup and then press h.
3
Press k / n on the remote control to select
Basic and then press h.
4
Select the desired parameters and then press
h to access and adjust.
y
• Most of the parameters described in the basic menu are set
automatically when you run AUTO SETUP. You can use the
basic menu to make further adjustments, but we recommend
running AUTO SETUP first.
• You can reset these parameters by performing the AUTO
SETUP procedure (see page 32).
■ Test Tone (Test tone)
Turns the test tone output on or off for Speaker Set,
Speaker Distance and Speaker Level settings.
Manual Setup > Basic > Test Tone >
Choices: Off, On
y
If you use a handheld SPL meter, hold at arms length and point
upwards so that the meter is in the listening position. With the
meter set to the 70 dB scale and to C SLOW, calibrate each
speaker to 75 dB.
Loud test tones will be output when “On” is selected. In this case,
make sure no children are present in the listening room.
■ Speaker Set (Speaker set)
Use to manually adjust any speaker setting.
Manual Setup > Basic > Speaker Set >
Choices: Front, Center, Surround, Surround Back,
Presence, Bass Out, Bass Cross Over, SWFR
Phase
y
If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
Set any THX speakers to Small.
Manual Setup (Basic)
GUI TOP
TITLE
BAND
AMP
SOURCE
TV
A-E/CAT.
ENTER
PRESET/CH
A-E/CAT.
ENTER
PRESET/CH
Test Tone
Speaker Distance
Speaker Level
Speaker Set Basic
Option
Video
Sound
A-E/CAT.
ENTER
PRESET/CH
A-E/CAT.
ENTER
PRESET/CH
A-E/CAT.
ENTER
PRESET/CH
Note
Note
Off
On Speaker Set
Speaker Distance
Test Tone
Bass Cross Over
SWFR Phase
Front
Surround
Center Speaker Distance
Speaker Level
Test Tone
Speaker Set