Wasp Bar Code WLS 9500 - Manual (Page 150)

WLS 9500 Product Reference Guide 8-8
FN1 Substitution Values
The Wedge and USB HID Keyboard hosts support an FN1 substitution feature. When enabled any FN1 character (0x1b)
in an EAN128 bar code is substituted with a value. This value defaults to 7013 (Enter Key).
To select an FN1 substitution value via bar code menus:
1. Scan the bar code below.
2. Look up the keystroke desired for FN1 Substitution in the ASCII Value Standard Default Parameters Table on
page D-1 for the currently installed host interface.
3. Enter the 4-digit substitution value by scanning each digit in Appendix C, Numeric Bar Codes .
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for keyboard wedge, scan the Enable FN1 Substitution bar code on page page 5-11 .
To enable FN1 Substitution for USB HID keyboard, scan the Enable FN1 Substitution bar code on page page 6-10 .
Transmit “No Read” Message
Scan a bar code below to select whether or not to transmit a No Read message. When enabled, the characters NR are
transmitted when a bar code is not decoded. When disabled, if a symbol does not decode, nothing is sent to the host.
*
Set FN1 Substitution Value
Enable No Read
*
Disable No Read