Wasp Bar Code WLS 9500 - Manual (Page 147)

Miscellaneous Scanner Options 8-5
Miscellaneous Scanner Parameters
Transmit Code ID Character
A Code ID character identifies the code type of a scanned bar code. This may be useful when the scanner is decoding
more than one code type. In addition to any single character prefix already selected, the Code ID character is inserted
between the prefix and the decoded symbol.
Select no Code ID character, a Symbol Code ID character, or an AIM Code ID character. For Code ID Characters, see
Symbol Code Identifiers on page E-3
and AIM Code Identifiers on page E-4.
Prefix/Suffix Values
A prefix and/or one or two suffixes can be appended to scan data for use in data editing. To set a value for a prefix or
suffix, scan a four-digit number (i.e., four bar codes from
Appendix C, Numeric Bar Codes ) that corresponds to that
value. See Table D-1 on page D-1 for the four-digit codes.
When using host commands to set the prefix or suffix, set the key category parameter to 1, then set the 3-digit decimal
value. See Table D-1 on page D-1 for the four-digit codes.
To correct an error or change a selection, scan Cancel on page C-4.
To use Prefix/Suffix values, first set the Scan Data Transmission Format on page 8-6.
Symbol Code ID Character
AIM Code ID Character
*
None