Wasp Bar Code WLS 9500 - Manual (Page 119)

Symbologies 7-31
Code 93
Enable/Disable Code 93
To enable or disable Code 93, scan the appropriate bar code below.
Set Lengths for Code 93
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the
code contains. Set lengths for Code 93 to any length, one or two discrete lengths, or lengths within a specific range.
• One Discrete Length - Select this option to decode only Code 93 symbols containing a selected length. Select
the length using the numeric bar codes in
Appendix C, Numeric Bar Codes . For example, to decode only Code
93 symbols with 14 characters, scan Code 93 - One Discrete Length, then scan 1 followed by 4. To correct an
error or to change the selection, scan Cancel on page
C-4 .
• Two Discrete Lengths - Select this option to decode only Code 93 symbols containing either of two
selected lengths. Select lengths using the numeric bar codes in
Appendix C, Numeric Bar Codes . For example,
to decode only those Code 93 symbols containing either 2 or 14 characters, select Code 93 - Two Discrete
Lengths, then scan 0, 2, 1, and then 4. To correct an error or to change the selection, scan Cancel on
page
C-4 .
• Length Within Range - Select this option to decode a Code 93 symbol with a specific length range.
Select lengths using the numeric bar codes in
Appendix C, Numeric Bar Codes. For example, to decode Code
93 symbols containing between 4 and 12 characters, first scan Code 93 - Length Within Range. Then scan
0, 4, 1, and 2 (single digit numbers must always be preceded by a leading zero). To correct an error or change
the selection, scan Cancel on page
C-4 .
• Any Length - Scan this option to decode Code 93 symbols containing any number of characters within the
scanner’s capability.
Enable Code 93
*
Disable Code 93