beautypg.com

Lockout lever location, Hourmeter, Oil pressure warning horn – Walker MC (20 HP) User Manual

Page 31: Circuit breaker (7 amp), Light switch (for optional lights), Operating instructions

background image

Operating Instructions

27

Lockout

Levers

Transmission

Plunger

Lockout Lever Location

NOTE: The transmission plunger on the side of the

transmission case (activated by the

LOCKOUT LE-

VER) must be completely released during operation

of the mower, otherwise operation of the transmis-

sion will be erratic.

Hourmeter

The hourmeter, which is located on the left front of

the body, displays

operating time accumulated

while the ignition switch is in the

ON position.

The hourmeter provides maintenance reminders af-

ter certain hours of operation. The hourmeter screen

will start flashing the reminder one hour prior to the

recommended interval and will continue until one

hour after the recommended interval (two hours).

The hourmeter

does not have a manual reset

function.

Procedure

Interval*

Reminder

Oil Change

(Break-In)**

4-6 Hours

C

H

G

OIL

Lubricate

and Check

Levels

24-26 Hours

LUBE

Oil Change

49-51 Hours***

C

H

G

OIL

* These intervals reflect the actual time that the

reminder will flash (one hour prior to and one

hour after the recommended interval).

** This reminder is only used one time.

*** In normal operating conditions, oil changes in

100-hour intervals are acceptable. Walker and

the engine manufacturers recommend engine

oil changes every 50 hours in extremely dirty or

dusty conditions or for units with less than 100

hours annual use.

NOTE: The blinking hour glass on the display

means that the meter is operating properly.

Hourmeter

Oil Pressure Warning Horn

The oil pressure warning horn indicates that engine

oil pressure is below the safe operating range [be-

low 3 to 5 PSI (21 to 34 kPa)]. This

horn will come

on when the ignition is turned

ON, but should go off

after the engine is started. If the horn fails to come

on when the ignition switch is turned

ON, it could

indicate a faulty horn. If the horn comes on during

engine operation, stop the engine immediately and

correct the source of the problem before further en-

gine operation.

IMPORTANT: Continued operation of the engine

with oil pressure warning horn sounding

MAY cause

severe engine damage (if a low oil pressure condi-

tion exists).

Circuit Breaker (7 Amp)

A 7-amp, manual-reset circuit breaker is located be-

low the ignition switch. The button pops up if the

circuit breaker trips. This circuit breaker protects the

circuits to the safety switch relays, time delay mod-

ule, and GHS.

Light Switch (For Optional Lights)

Operates headlights (when installed).