White Rodgers 1F95W-80 - Manual (Page 34)

34
RUN
PRGM
to begin the factory preset program.
Or you may reprogram the thermostat, then
replace it on the wall.
To prevent further static discharge prob-
lems, touch another object to release static
build-up before touching the thermostat.
See OPERATING YOUR THERMOSTAT.
6. Why won’t the setpoint temperature go
to the temperature I want?
The highest heating setpoint temperature
you select must be at least 1
°
F lower than
the lowest cooling setpoint temperature you
select (for example, if 70
°
F is your lowest
selected cooling temperature, you cannot
select a heating temperature any higher
than 69
°
F). If such a conflict exists, you
must set the lowest cooling temperature
higher in order to set the heating tempera-
ture higher. To set a lower cooling tempera-
ture, you must select a lower heating tem-
perature. See PROGRAMMING YOUR
THERMOSTAT.
7. Why doesn’t the display light come on
when I press a button? Why don’t I hear
a beep when I press a button?
The display light and audio prompting (beep)
only work when the thermostat is on the wall
and 24 VAC power is present to the thermo-
stat. These features will not work on battery
power alone. See OPERATING YOUR
THERMOSTAT.