White Rodgers 1F95W-80 - Manual (Page 32)

32
1. How can I permanently change a part of
my program?
Press VIEW
PRGM
and ADV
DAY until you reach the
time/temperature schedule you want. Then
press or and TIME
FWD and TIME
BACK
to
change the program. See PROGRAMMING
YOUR THERMOSTAT.
2. How can I finish my programming if the
display has already changed to time/
temperature?
During programming, if no buttons are
pressed for five minutes, the thermostat will
enter the HOLD mode and maintain a con-
stant temperature. The display will change
to the time/temperature mode. To resume
programming, press VIEW
PRGM
and ADV
DAY until
you return to the point where you stopped
programming. Then you may continue to
program the thermostat normally. If you
want to stop programming at this point,
press RUN
PRGM
to start the normal program
function. See PROGRAMMING YOUR
THERMOSTAT.
3. What happens if the electricity goes off
or is manually shut off?
If you have not installed a 9 volt alkaline
battery, the display will go blank and the
program will be lost in five seconds. When
electricity is restored, the thermostat will
maintain a heating temperature of 64
°
F and
QUESTIONS AND ANSWERS