Wayne-Dalton 341785 - Manual (Page 30)

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
30
Tools Needed:
Trolley Operator
OPERaTOR MusT bE TEsTED
aT TIME OF INsTallaTION aND
MONThly ThEREaFTER TO
ENsuRE ThaT DOOR REVERsEs
ON CONTaCT WITh 2 x 4 bOaRD
laID FlaT uNDER ThE DOOR.
FaIluRE TO aDjusT OPERaTOR,
IF NECEssaRy, CaN REsulT IN
sEVERE OR FaTal INjuRy. IF yOuR
OPERaTOR Is EquIPPED WITh a
PhOTOElECTRIC EyE sysTEM,
ThEN ThIs MusT bE TEsTED
aT ThE saME TIME TO ENsuRE
ThaT DOOR DOEs NOT ClOsE
aND a ClOsING DOOR OPENs IF
PhOTOElECTRIC EyE sysTEM Is
ObsTRuCTED. FaIluRE TO MakE
aDjusTMENTs, IF NECEssaRy,
CaN REsulT IN sEVERE OR FaTal
INjuRy.
1. Install operator rail 1/2” to 1”
(13 - 38 mm) above high arc of top
section of the door.
2. Mount operator to ceiling so that
1” to 1-1/2” (25 - 38 mm)
clearance is maintained between
trolley rail and top section when
door is fully open (trolley rail will
slope down towards rear).
3. attach door arm to operator bracket
installed in step 9.
4. attach operator rail to suitable
mounting surface 2 x 6 lumber
minimum.
5. attach operator to ceiling using
perforated angle.
IMPORTANT: aNGlEs MusT bE
sECuREly aTTaChED TO sOuND
FRaMING MEMbER(s).
hEaDER
FRaMING MEMbERs
PERFERaTED aNGlE
OPERaTOR
RaIl
PERFERaTED
aNGlE
OPERaTOR RaIl
WARNING suITablE
MOuNTING
suRFaCE 2 x 6
luMbER MINIMuM
DOOR aRM TO OPERaTOR bRaCkET
OPERaTOR