Wayne-Dalton 341785 - Manual (Page 12)

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
12
Tools Needed:
Tools Needed:
NOTE: If you have fully adjustable jamb
brackets, skip this step and complete
step 4.
Measure the length of the vertical tracks.
using the jamb bracket schedule,
determine the placement of the jamb
brackets for your door height and track
type. To install the jamb brackets,
align the twistlock tab on the quick
install jamb bracket with the quick
install feature in the track and turn the
bracket perpendicular to the track so the
mounting flange is toward the back (flat)
leg of the track.
NOTE: after completing this step,
continue with step 5.
Installing quick Install
Jamb Brackets
TOP
hOlE
bOTTOM
hOlE
MIDDlE
hOlE
JAMB BRACkET SChEDULE
DOOR
hEIGhT
1ST SET 2ND SET 3RD SET
JAMB BkT POSITION JAMB BkT POSITION JAMB BkT POSITION
8’0”
96” TRACk
qIjb - 3 bOTTOM qIjb - 7 TOP qIjb - 8 TOP
3RD sET hOlEs
2ND sET hOlEs
1sT sET hOlEs
None
3
quICk INsTall FEaTuRE
qI jaMb bRaCkET
TWIsTlOCk Tab
lEFT sIDE shOWN RIGhT sIDE shOWN
Attaching fully Adjustable
flagangle to Vertical Track
1/4”- 20
FlaNGE hEx
NuTs
NOTE: If quick install flagangle was
installed in step 1, skip this step and
continue with step 3. If not, complete
this step.
hand tighten the flagangle to the vertical
track using (2) 1/4” - 20 x 9/16” large
head ribbed track bolts (or stud plate if
included) and (2) 1/4” - 20 flange hex
nuts. Repeat for other side.
secure the flange nuts after flagangle
spacing is complete (step 10).
Fully aDjusTablE FlaGaNGlE
1/4” - 20 x 9/16”
laRGE hEaD RIbbED
TRaCk bOlTs
None
VERTICal TRaCk
2
sTuD PlaTE
(IF INCluDED)