Warning – Wayne-Dalton 341785 User Manual

Page 25

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at

www.wayne-dalton.com

Tools Needed:

INST

ALLA

TION

Counterbalance Cables

Vice Grips

3/8” Wrench

Release the vice grips from the ends of
the cables and thread the
counterbalance cables around the back
side of the left cable drum and verify
that there is no cable obstructions. hook
the cables into the drums. slide the left
hand cable drum against the left hand
end bearing bracket and tighten the set
screws in the drum to 14-15 ft. lbs. of
torque (Once set screws contact the
tube, tighten screws one full turn).
Rotate the left hand drum and torsion
tube until cable is taut. attach vice grips
to torsion tube and brace vice grips
against jamb to keep cable taut. slide
the right hand cable drum against the
right hand end bearing bracket and
rotate drum until cable is taunt. Tighten
set screws in right hand cable drum.

IMPORTANT: ChECk EaCh CablE,
MakING suRE bOTh aRE sEaTED
PROPERly ON ThE CablE DRuMs aND
haVE Equal CablE TENsION.

Place vice clamps onto both vertical
tracks just above the third Roller. This
is to prevent the garage door from
raising while winding torsion spring(s).

FaIluRE TO PlaCE VICE ClaMPs

ONTO VERTICal TRaCk CaN

allOW DOOR TO RaIsE aND

CausE sEVERE OR FaTal

INjuRy.

Securing Door

for Spring Winding

Vice Clamp

WARNING

lEFT END bEaRING bRaCkET

CablE IN
POsITION

sET

sCREWs

VICE GRIPs

jaMb

lEFT CablE

DRuM

lEFT CablE DRuM

CablE

hOOkED IN

CablE DRuM

TRaCk

VICE ClaMPs

aTTaChED TO

INNER RaIl

OF TRaCk

PlaCE VICE ClaMPs

abOVE 3RD ROllER ON

bOTh VERTICal TRaCks

TORsION

TubE