Wayne-Dalton TORQUEMASTER 3663-372 - Manual (Page 43)

❉
Programming HomeLink ® System to the Torquemaster ® idrive ® (Alternate)
Programming/Training HomeLink ® Unit
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
1. Pull the manual disconnect to put the opener in the disengaged
position.
2. Press and hold the two outside buttons on the HomeLink ®
unit until the HomeLink ® light begins to flash rapidly (approx. 20
seconds), then release both buttons. (Do not perform this step to
train additional hand-held transmitters.) NOTE: This operation
erases all previously learned transmitters and that you need to
re-teach any other transmitters to your HomeLink ® unit by
repeating steps 3 - 6 below.
3. Hold the end of the Wayne ® Dalton hand-held transmitter
approximately 1 to 3 inches away from the HomeLink ® surface –
keeping the HomeLink ® indicator light in view.
4. Use the large button on the Wayne Dalton transmitter.
Simultaneously press and hold desired Homelink ® button and the
Wayne Dalton transmitter large button. Continue to press both
buttons counting LED flashes on the HomeLink ® module;
between 50 to 60 LED flashes the LED will either come on solid
or do one “quick flash”; when either of these occur release both
Wayne Dalton transmitter and HomeLink ® buttons.
Teaching HomeLink ® to the idrive ® Opener
5. Press and release the red program button on the idrive ® opener.
The idrive ® unit will beep, indicating that it is ready to learn.
NOTE: The idrive ® will remain in the learn mode for 30 seconds.
6. Press the HomeLink ® button used in Step 4 above for 1 to 3
seconds. The idrive ® will beep indicating a successful learn.
7. Return the manual disconnect to the engaged position.
8. Press the HomeLink ® button once more to operate the door.
NOTE: The first transmitter command after programming will only move
the door through a six inch up/down cycle. Normal door operations will
occur on the second use of the transmitter.
NOTE: This Step can only be done on automobiles equipped with the
HomeLink
® system.
NOTE: Programming HomeLink ® requires a Wayne-Dalton Transmitter
that is programmed to the opener (the wallstation and transmitter(s)
supplied with the opener, come pre-programmed from the factory). Any
additional wallstation(s) or transmitter(s) will need to be programmed to
the opener, see page 40.
IMPORTANT! Use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
® unit does not
learn the transmitter, when using the vehicle’s instructions.
NOTE: Vehicle may need to be in accessory position when
programming. Check car owner’s manual.
NOTE: HomeLink ® is a registered trademark of Johnson Controls.
WARNING
36
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
OPERA
TION