Save these instructions – Wayne-Dalton TORQUEMASTER 3663-372 User Manual

Page 40

❉

TO REDUCE THE RISK OF SEVERE
INJURY OR DEATH:

1. READ AND FOLLOW ALL INSTRUCTIONS.

2. Never let children operate or play with the door controls.

Keep remote controls away from children.

3. Always keep a moving door in sight and keep people and objects

away until it is completely closed. NO ONE SHOULD CROSS THE
PATH OF A MOVING DOOR.

4. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.

5. Test the Door/Opener monthly. The garage door MUST reverse on

contact with a 1-1/2” high object (or a 2 x 4 board laid flat) on the
floor. The door MUST also reverse when a 6” high object is placed on
the floor in line with safety sensors. If Door/Opener fails these tests,
have adjustments/repairs made immediately. Failure to make
adjustments/repairs may cause severe or fatal injury.

6. When possible, use the Emergency Disconnect only when the door is

in the closed position. Be very cautious using the Emergency
Disconnect when the door is open. Weak or broken spring(s) may
allow the door to fall rapidly, causing a severe or fatal injury.

7. KEEP THE GARAGE DOOR PROPERLY BALANCED. See the owner’s

manual included with the door. An improperly balanced door could
cause a severe or fatal injury. Have a qualified service person make
repairs to the cables, spring assemblies, and other hardware.

SAVE THESE INSTRUCTIONS.

Door activation:

Upon activation by either the Wall Station Up/Down Button or
Transmitter, the door will move in the following manner:

1. If closed, the door will open. If open completely, the door will close. If

partially open, the door will close.

2. If closing, the door will stop, reverse, and return to the open position.

Next activation will close the door.

3. If opening, the door will stop. Next activation will close the door.

4. If an obstruction is encountered or an out-of-balance condition is

detected while the door is closing, the door will reverse, return to the
open position, and the opener will beep 3 or 4 times. The next
activation will close the door.

5. If an obstruction is encountered or an out-of-balance condition is

detected while opening the door, the door will stop. The next
activation will close the door.

6. When door is in motion any button on the wall station functions the

same as the Up/Down button.

ALWAYS KEEP MOVING DOOR IN SIGHT AND KEEP PEOPLE AND
OBJECTS AWAY UNTIL IT IS COMPLETELY CLOSED. TO PREVENT A
SEVERE OR FATAL INJURY, AVOID STANDING IN A OPEN DOOR WAY
OR WALKING THROUGH THE DOORWAY WHILE THE DOOR IS
MOVING.

NEVER LET CHILDREN OPERATE DOOR OR PLAY WITH THE DOOR
CONTROLS. KEEP REMOTE CONTROLS AWAY FROM CHILDREN.
FATAL INJURY COULD RESULT SHOULD A CHILD BECOME TRAPPED
BETWEEN THE DOOR AND FLOOR.

KEEP THE GARAGE DOOR PROPERLY BALANCED. AN IMPROPERLY
BALANCED DOOR COULD CAUSE SEVERE OR FATAL INJURY. HAVE A
QUALIFIED SERVICE PERSON MAKE ADJUSTMENTS/REPAIRS TO
CABLES, SPRING ASSEMBLIES, AND OTHER HARDWARE.

Emergency Disconnect:

THE EMERGENCY DISCONNECT SHOULD ONLY BE USED WHEN DOOR
IS CLOSED. USE EXTREME CAUTION IF OPERATING THE EMERGENCY
DISCONNECT ON AN OPEN DOOR. WEAK OR BROKEN SPRING(S) MAY
ALLOW THE DOOR TO FALL RAPIDLY, CAUSING SEVERE OR FATAL
INJURY.

The opener is equipped with an emergency disconnect that allows the
door to be moved manually and independently from the opener.

With the door closed, pull down on the disconnect handle and place the
handle under the lower section of the handle bracket. This motion
causes the motor on the opener to pivot upwards and the opener to
disconnect from the torque tube.

Releasing the disconnect handle from the lower section on the handle
bracket and returning the handle to its original position will reconnect
the opener to the torque tube.

NOTE: The motor will not pivot down completely when the handle is
released. After one motorized up/down door cycle, the motor will once
again pivot down, and all cable slack will be taken up. The garage door
is not secured from forced entry until the motor is back in the down
position.

Disconnect Label: The label is located next to the disconnect handle.
The label shows the handle in both the motor operated and manual
operated positions. View on the left side of the label shows the handle
position when the opener is engaged to the torque tube. The view on the
right side of the label shows the handle when the opener is disconnected
from the torque tube.

IMPORTANT SAFETY INSTRUCTIONS

WARNING

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com