Positioning support bracket, Attaching opener to support bracket, Idrive – Wayne-Dalton TORQUEMASTER 3663-372 User Manual

Page 19: For torquemaster, Inst alla tion

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Positioning Support Bracket

NOTE:

idrive

must be installed on a solid

wood mounting surface.

Locate the mounting surface. The mounting
surface is a vertical board running directly
above the center of the door. Remove
(2) 1/4”-20 flange nuts from bottom
of opener.

NOTE:

Do not discard flange nuts.

Place the support bracket underneath
opener, to the right side of motor, centered
on mounting surface.

Using a tape measure, maintain equal
measurements between torque tube and top
of door at both ends and in center to ensure
torque tube is level. Once torque tube is
level, with idrive resting on support bracket,
drill 1/8” pilot holes for the lag screws.

Now secure support bracket to the mounting
surface with (2) 1/4” x 1-1/2" lag screws.

NOTE:

If wood mounting surface is covered

with dry wall, use 1/4” x 2” lag screws.

1/4 x 1-1/2”

Lag Screws

Support
Bracket

1/4” - 20

Flange Nuts

Mounting

Studs

Mounting

Surface

(Header)

Top Of Door

Learn

Delete

Controls

www.Wayne-Dalton.com/access

Find out more:

what’s

OPENING

your world?

With Z-Wave

technology you can

control your lights,

thermostat and start
your morning coffee,

all withthe single

touch of a button.

P/N 335982

Z-Wave

enabled

Attaching Opener To

Support Bracket

Lift and slide the opener over the support
bracket, aligning the mounting studs with
the bracket slots. Loosely fasten to
mounting studs with the (2) 1/4”-20
flange nuts.

Alternately, the disconnect cable can be
pulled to allow motor to pivot up. This will
enable assembly of the support bracket to
the opener first, followed by leveling of the
torque tube and then attachment of support
bracket to mounting surface.

NOTE:

Do not tighten 1/4”-20 flange

nuts to opener studs at this time.

Remove the orange label holding the
antenna wire. Straighten antenna wire and
angle it 45 degrees to the right.

NOTE:

Do not coil the antenna wire. This

will reduce the radio signal range.

Antenna Wire

(2) 1/4”-20

Flange Nuts

Support
Bracket

Mounting

Studs

45° Angle

Tools Needed:

Step Ladder

Bracket

Slots

Torque Tube

USING A TAPE MEASURE, MAINTAIN AN EQUAL MEASUREMENT “X” (TOP OF DOOR

TO BOTTOM OF TORQUEMASTER

TUBE) AT BOTH ENDS AND THE CENTER.

TOP SECTION

“X”

Tools Needed:

Power Drill

1/8” Drill Bit

7/16” Socket

Driver

Tape Measure

Step Ladder

IDRIVE

FOR TORQUEMASTER

INST

ALLA

TION