Wacom Cintiq 18SX - Manual (Page 56)

54
Using an Alternate Mount or Stand
If you plan to use Cintiq in an installation that
requires the use of an alternate mounting plat-
form, you can mount the Interactive Pen Dis-
play onto a VESA conforming mount arm or
stand. A VESA mounting platform will require
mount screws that are 4 mm wide with a
0.7 mm pitch (M4 Regular), and a maximum
screw clearance depth of 10 mm. Exceeding
the clearance depth of 10 mm will damage
Cintiq internal components. The hole pattern
should be a 100 x 100 mm square. The VESA
mounting platform will also require an aper-
ture of sufficient clearance to accomodate the
Cintiq cable and bearing hub (70 mm diam-
eter).
To attach Cintiq to a different mounting plat-
form:
1. Turn off your computer and power off
Cintiq. Then disconnect all cables from
between the unit and your computer.
2. If Cintiq is mounted, remove it from the
display stand.
3. Protect the display screen surface by
spreading a soft cloth onto a flat table and
placing Cintiq face down on the cloth.
4. Using the appropriate screws for your
mounting platform, firmly attach Cintiq to
the alternate mounting platform. Be sure
the integral cable and bearing mount pass
through the mount aperture without bind-
ing or excess pressure.
5. Refer to the appropriate installation
instructions, beginning on page 18, and
reattach the cabling.
When attaching Cintiq onto an alternate
mounting platform, be sure to follow all
instructions in the documentation supplied
by the platform manufacturer. If improp-
erly installed, the unit could fall, resulting
in damage to the unit or physical injury. CAUTION
Aperture (70 mm dia.) for
cable and bearing hub.