Vertex Standard TRANSCEIVER VX-1700 - Manual (Page 28)

28
CE77 PC Programming Software
HARDWARE PARAMETERS
Put a check mark into the check box to enable ad-
justment of its parameter from the transceiver’s set
(“menu”) mode.
The available parameters are: 1.6 - 4 MHz RF Pow-
er, 4 - 30 MHz RF Power, Dimmer Level-1, and Dim-
mer Level-2.
1.6 - 4 MHz RF POWER
This parameter programs the TX output power
on the 1.6 - 4 MHz band for each power setting
level.
To program the TX output power, double click
the left mouse button on this column; enter de-
sired TX output power from the keyboard, then
press the [ENTER] key to accept the new TX out-
put power.
The available values are “10 (W)” to “125 (W)”
for “High” power setting on the 1.6 - 4 MHz band,
and “10 (W)” to “125 (W)” for “High” power set-
ting on the 4 - 30 MHz band, “Medium” power
setting, and “Low” power setting.
4 - 30 MHz RF POWER
This parameter programs the TX output power
on the 4 - 30 MHz band for each power setting
level.
To program the TX output power, double click
the left mouse button on this column, enter de-
sired TX output power from the keyboard, then
press the [ENTER] key to accept the new TX out-
put power.
The vailable values are “10 (W)” to “100 (W).”
DIMMER LEVEL - 1
This parameter programs the Display Back-light
Level and Back-light Options when “DIM” is not
selected.
The available Back-light Levels are “1” to “10,”
and “OFF.”
The available Back-light Options are “ON” (al-
ways on) and “Key On 10S” (Back-light on for
ten seconds after any key stroke).
DIMMER LEVEL - 2
This parameter programs the Display Back-light
Level and Back-light Options when “DIM” is se-
lected.
The available Back-light Levels are “1” to “10,”
and “OFF.”
The available Back-light Options are “ON” (al-
ways on) and “Key On 10S” (Back-light on for
ten seconds after any key stroke).
"H
ARDWARE
" P
ARAMETERS