VIEWSONIC PJ650 - Manual (Page 35)

ViewSonic PJ650 32
Lamp Life
Projector lamps have a finite life. The projected images will become darker and hues will become weaker
after a lamp has been used for a long period of time.
The LAMP indicator also becomes red when the lamp unit reaches a high temperature. Before replacing the
lamp, switch the POWER OFF, wait approximately 20 minutes, then switch the POWER ON again. If the
LAMP indicator still displays red, replace the lamp.
Replacing the Lamp
All projector lamps will wear out eventually. If used for long periods of time, the image could become
darkened, and the color contrast could be impacted as well. We recommend that you replace your lamps early.
If the LAMP indicator turns red, or a message prompts you to replace the lamp when you power up the
projector, the lamp needs to be replaced.
1 Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at least 45 minutes, and
prepare a new lamp
2 After making sure that the projector has cooled adequately, slowly flip over the projector, so that the
bottom is facing up
3 Unscrew the 2 screws, and remove the lamp cover
4 Unscrew the 1 screw, and slowly pull out the lamp by the handle
• Be careful not to touch the inside of the lamp case.
5 Insert the new lamp, and tighten the 1 screw firmly to lock it in place
• Also steadily push the opposite side of the screwed side of the lamp into the unit.
6 Replace the lamp cover, and tighten the 2 screws firmly to lock it in place
7 Slowly turn the projector so that the top is facing up
8 Turn on the projector power, and using the menu, reset the lamp timer
• To reset the lamp timer, from the OPTION menu, select LAMP TIME.