VIEWSONIC PJ650 - Manual (Page 18)

15 ViewSonic PJ650
Turning Off The Power
1 Press the STANDBY/ON button (control panel or remote control)
The message "Power off?" will appear on the screen for approximately 5 seconds.
2 Press the STANDBY/ON button again
(control panel or remote control)
Press the STANDBY/ON button again while the "Power off?" message is visible. The projector lamp goes
off and starts cooling down. The POWER indicator blinks orange while the lamp cools down. (Pressing
the STANDBY/ON button while the POWER indicator is blinking orange has no effect.)
The system goes into STANDBY mode, after cooling down the POWER indicator stops blinking orange
and then lights to solid orange.
3 Check that the POWER indicator stops blinking and lights to
solid orange.
Switch the power switch to [O] (OFF).
4 Confirm that the POWER indicator has gone off and then
attach the lens cap.
When the projector has completed powering down, the
POWER indicator will go off.
NOTE:
Except in emergencies, follow the abovementioned procedure for turning power off.
Control panel
POWER indicator
power switch