VIEWSONIC PJ650 - Manual (Page 25)

ViewSonic PJ650 22
Signal Searching
1 Press the SEARCH button
When you press the SEARCH button, the projector begins searching for input signals. If it detects an input
signal, the search will cease and the projector will project the detected signal. If the projector is unable to find
an input signal at any of its ports, it will return to the state it was in prior to the search.
Selecting the Aspect Ratio
1 Press the ASPECT button
RGB IN 1, RGB IN 2, COMPONENT VIDEO
(HDTV signals : 1125i (1035i/1080i), 750p)
4:3 16:9
VIDEO IN, S-VIDEO IN, COMPONENT VIDEO
(Non-HDTV signals : 525i, 525p,625i)
Temporarily Blanking the Screen
1 Press the BLANK button
The input signal screen is shut off, and a blank screen appears. You can set the blank screen using the
menu (from the SCREEN menu, select BLANK). Press the BLANK button again to remove the blank
screen, and return to the input signal screen.