VIEWSONIC PJ452 - Manual (Page 34)

ViewSonic PJ452 30
IMAGE menu
With the IMAGE menu, items shown in the table below can
be performed.
Choose an item using the cursor buttons ▲/▼ on the
projector or remote control, and press the cursor button ►
on the projector or remote control, or the ENTER button on
the remote control to progress. Then perform it referring to
the following table.
Item Description
ASPECT Using the buttons ▲/▼ switches the mode for aspect ratio.
At a RGB signal
4:3 16:9 NORMAL
═════════
At a video signal / no signal
4:3 16:9
═══
• The NORMAL mode keeps the original aspect ratio of the
signal.
• At a HDTV component video signal of 1125i (1080i) or 750p
(720p), this item can’t be chosen.
• Performing the automatic adjustment initializes the aspect
ratio setting.
OVER SCAN Using the buttons ▲/▼ adjusts the over-scan ratio.
Large (It reduces picture) Small (It magnifies picture)
• This item can be chosen only at a video signal.
• When this adjustment is too large, certain degradation may
appear at the frame area of the picture. In such a case, please
adjust small.
V POSITION Using the buttons ▲/▼ adjusts the vertical position.
Up ↔ Down
H POSITION Using the buttons ▲/▼ adjusts the horizontal position.
Left ↔ Right
H PHASE Using the buttons ▲/▼ adjusts the horizontal phase to
eliminate flicker.
Right ↔ Left
• This item can be chosen only at a RGB signal or a component
video signal (except 525i (480i) and 625i (576i)).