Universal Remote Control (URS) WR7 - Manual (Page 31)

Page 31
Erasing All Learned Commands from
One Component
This function allows you to erase all the
learned commands from one component.
For example, if you want to erase all
learned commands on the TV component
button because you bought a new TV, the
process is very simple.
STEP 1: Press the component button where
all the learned commands are stored and the
[ENTER] button at the same time for two sec-
onds until the component LED turns on.
IMPORTANT: You have 30 seconds to
perform the next step while you are in pro-
gramming mode. If you do not press a but-
ton within 30 seconds, the component LED
light will turn off. The remote will exit the
programming mode and you will have to
start over.
STEP 2: Press and hold both the component
button you want to erase and the [PAUSE] but-
ton at the same time for two seconds, until the
component LED light blinks twice to confirm
the erasure.
STEP 3: To exit Erase mode, press and
hold both the component button and the
[ENTER] button at the same time until the
component LED light blinks three times.
COMPONENT
BUTTONS
ENTER
PAUSE