Universal Remote Control (URS) WR7 - Manual (Page 24)

Page 24
STEP 3: Using the Number Pad, punch in
the Channel number of the Favorite Channel
that you want to store in the Macro button.
The CABLE/SAT component LED light will
blink once for each button pressed.
STEP 4: Press the CHANNEL UP [CH ]
button to store the commands entered. The
[CABLE/SAT] component LED will blink three
times to confirm the programming.
Notes regarding programming
multi-commands to Macro buttons:
• You can program up to 20 commands on
each Macro button.
• You can program delays in between com-
mands by pressing the [PAUSE] button.
Each press adds a one-half second delay.
• Also, if you add the delay time as the first
step of Macro commands, the remote will
not send the Macro unless the button is
held for two seconds. (This is the Press &
Hold Function).
• You can also program macro commands in
“ layers” by pressing the [STOP] button in
between commands. (For example, if you
press [009], [STOP], [035], [STOP], [365],
[STOP] in Step 3 of the Favorite Channel
programming process) the remote will send
out 009 at the first press of the selected
[My Favorites] button, and then send out
035 at the second press, etc.
• You cannot program the [CH ] or
[PAUSE] buttons as macro commands.
CHANNEL
UP