Universal Remote Control (URS) WR7 - Manual (Page 12)

Page 12
IMPORTANT: You have 30 seconds to
perform the next step while you are in pro-
gramming mode. If you do not press a but-
ton within 30 seconds, the component LED
light will turn off. The remote will exit the
programming mode and you will have to
start over.
STEP 5: Point the WR7 toward the compo-
nent (in this example the TV) and punch in
the first 3-digit code that you wrote down for
that specific component. Use the Number
buttons 0~9 on the remote to punch in the
code. The TV LED light will blink each time a
number is pressed.
If the 3-digit code number you just punched
in is the correct number, the component you
are trying to program will turn off. If it did
not turn off, enter the next code number
from your list until it does turn off.
STEP 6: Once you’ve entered the code
number and the component has turned off,
press the POWER [ON] button on the WR7
remote to turn the component back on.
Next test the VOLUME and CHANNEL but-
tons (or PLAY and STOP buttons for VCR and
DVD) to make sure they all work. For exam-
ple, perhaps your Sony TV turned off with
code number 147, but the volume controls
did not work properly. In this case, try the
next code number listed for that component.
Repeat Step 5 using the next code number
until you find a perfect match.
NUMBER
BUTTONS