Please do not return, Page 15, This product to the store – Universal Remote Control (URS) WR7 User Manual
Page 15
Page 15
STEP 3:
Point the WR7 remote control
toward the component and press the UP [
]
arrow (or DOWN [
] arrow) button once.
Each time the UP or DOWN arrow button is
pressed, the code will count up (or down) one
code number and send a Power OFF signal.
When the correct code is sent out, the compo-
nent will turn off.
STEP 4:
Once you have found the right code
number and the component has turned off,
press the POWER [ON] button on the WR7
remote to turn the component back on.
Next test the VOLUME and CHANNEL buttons
(or PLAY and STOP buttons for VCR and DVD)
to make sure they all work. If any of the buttons
do not work properly, you need to find a new
code. Continue pressing the UP (or DOWN)
arrow button until you find a new code that
turns off the component and makes the VOL-
UME or PLAY buttons respond correctly.
STEP 5:
Once you have found the right
code, you must save it. Press the compo-
nent button you just programmed (in this case
TV) one more time to save the code number.
The component LED light will blink three times
to confirm that the code was successfully stored.
Now when you press the TV component button,
all of the buttons will work with your TV.
NOTE:
Use this method for those components
you cannot program with either the Quick Set-
Up or 3-digit Code Entry Methods.
IMPORTANT:
If you cannot find the right
code after 5 minutes of trying the Auto-Search
Method, try the Learning Method (page 16).
PLEASE DO NOT RETURN
THIS PRODUCT TO THE STORE
PLEASE CONTACT OUR TECHNICAL
SUPPORT CENTER.
IF YOU NEED ASSISTANCE E-MAIL
or dial
1-800-901-0800
(9:00AM - 6:00PM EST)