Nikon SB-900 - Manual (Page 121)

F–5
F
Ti
ps on Speedlight care and reference information
Notes on continuous flash shooting
To prevent the SB-900 from overheating, allow the SB-900 to cool down for at least
10 minutes after the maximum number of continuous firings have been performed
as shown in the table below.
Setting the “Thermal Cut-out” function is recommended. (kF-6) •
Maximum number of continuous fi rings
Flash mode
Max. number of continuous
fi rings (at 6 frames/sec.)
i-TTL
Non-TTL auto
Manual flash mode (flash output level: M1/1, M1/2
)
•
•
•
15 or less
Manual flash mode (flash output level: M1/4 to M1/128) • 40 or less
Do not exceed the maximum number of continuous firings,
as this may cause the SB-900 to overheat or degrade.
"
WARNING
v
Notes for battery temperature
While operating continuous flash shooting, batteries may also generate heat.
When replacing batteries after continuous flash shooting, note not to get burned.