Tandberg Data 3000MXP - Manual (Page 98)

TANDBERG 3000 MXP User Manual
94
Ethernet Speed
Auto The codec will auto-detect the speed/duplex on the LAN.
10/Half The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/Full 10 Mbps speed/Full Duplex.
100/Half 100 Mbps speed/Half Duplex.
100/Full 100 Mbps speed/Full Duplex.
IP Access Password
By setting an IP Access Password on the system, all access to the system using IP (Telnet,
FTP and WEB) requires a password. The default IP Access Password is
“
TANDBERG
”
.
4.8.2.2 H.323 Settings
4.8.2.2.1 E.164 alias
This is the E.164 address of the system. The E.164 address is equivalent to a telephone
number, sometimes combined with access codes. Valid characters are 0-9,* and #. When
using a gatekeeper, the system will send a message to the gatekeeper containing both the
E.164 address and the system name of the system. The system will not register with the
gatekeeper if the E.164 alias is not set.
4.8.2.2.2 H.323 Call Setup
Direct An IP-address must be used in order to make a H.323 call. The system will
not use a gatekeeper or call manager
Gatekeeper The system will use a gatekeeper to make a H.323 call (the system will still
be able to place calls directly to an IP-address without using the
gatekeeper).
Call
Manager
The system will use a call manager to make a H.323 call (the system will
still be able to place calls directly to an IP-address without using the call
manager).
4.8.2.2.3 Gatekeeper Discovery
Auto The system will automatically try to register on any available gatekeeper. If a
gatekeeper responds to the request sent from the codec within 30 seconds this
specific gatekeeper will be used. If no gatekeeper responds, the system will not
use a gatekeeper for making H.323 calls and hence an IP-address must be
specified manually.