Tandberg Data 3000MXP - Manual (Page 95)

4 Administrator Settings
91
4.8 Network
The network menu contain:

ISDN-BRI Settings

LAN Settings

Network Profiles

Data Port
4.8.1 ISDN-BRI Settings
To make sure your system will work properly using ISDN-BRI, make the following
settings:
1. Set ISDN switch type
2. Enter ISDN line numbers (+ SPIDs if required)
3. Disable unused lines
Some software versions do not support 6 ISDN lines, therefore some of the Line Setup
entries may be grayed out.
4.8.1.1 ISDN switch type
Select the type of ISDN network connected to your unit. Note that 1TR6 should only be used
if you are operating the system behind a PABX.
4.8.1.2 Line setup
This menu allows you to program the numbers associated with your ISDN line. If you want to
use this ISDN line, you need to set Enabled On and enter the numbers of your ISDN line. If
some of the ISDN lines are not to be used, set Enabled Off. Line 1 should always be enabled.
National ISDN and AT&T Custom ISDN might require SPID numbers associated with your
ISDN numbers. If you have received two different SPID (Service Profile IDentifier) numbers
for each ISDN line from your network provider, you must program both.