Toshiba IK - HD1C - Manual (Page 6)

6
1 Camera Control Unit ............................................................................................... 1
2 Accessories
a Instruction manual ........................................................................................ 1
2. COMPONENTS
1. CAUTIONS ON USE AND INSTALLATION
• Handling the unit.
• Do not shoot intense light.
If there is an intense light at a location on the
screen such as a spot light, a blooming and smear-
ing may occur. When intense light enters, vertical
stripes may appear on the screen. This is not a
malfunction. Ghosts may occur when there is an
intense light near the object. In this case, change
the shooting angle.
• Install the camera in a location free from noise.
If the camera or the cables are located near power
utility lines or a TV, etc. undesirable noise may ap-
pear on the screen. In such a case, try to change
the location of the camera or the cable wiring.
• Moire
• Operating ambient temperature and humidity.
Do not use the camera in places where tempera-
ture and humidity exceed the specifications. Pic-
ture quality will deteriolate and internal parts may
be damaged.
Be particularly careful when using in places ex-
posed to direct sunlight. When shooting in hot
places, depending on the conditions of the object
and the camera (for example when the gain is in-
creased), noise in the form of vertical strips or
white dots may occur. This is not a malfunction.
• Handling of the camera head and protection
cap.
• When not using the camera for extended
periods of time.
• When cleaning the camera.
• Avoid using or storing the camera in the fol-
lowing places:
• Installation without a tripod.
Do not drop, jolt, or vibrate, as this may result in
damage to the unit. This may cause problems.
Treat the camera cables carefully to prevent
cable problems, such as breaks in the cable and
loose connections.
Keep the camera head and protection cap away
from as they may pose a choking hazard. The
protection cap protects the image sensing plane
when the lens is removed from the camera head,
do not discard.
Unplug the power source before cleaning. Clean
with a soft dry cloth only. Do not use chemicals or
chemically treated cloths. Chemicals may damage
coatings and printed letters. When cleaning the
lens, use lens cleaning paper.
Before installing the camera head, make sure
that the location can withstand the total weight of
the camera head.
If this is not the case, reinforce the area to
prevent the unit from dropping, which may result
in damage to the unit or personal injury.
Places filled with highly flammable gas.
Places near gasoline, benzene, or paint thinner.
Places subject to strong vibration.
Places containing chemicals (such as pesticides),
rubber or vinyl products for extended periods of
time.
Switch the control unit off and disconnect the
power supply.
A moire pattern is an interference pattern
generated when two repetitive line patterns
overlap. This is not a malfunction. Eliminating the
repetitive line patterns, or aligning the two
patterns, will eliminate the moire.
The following descriptions are for that a camera
head "IK-HD1H" connected to this camera control
unit.